CLEAT SETTING

brannock_device_2_mv_mv
Precise Shoe Fitting with SHIMANO Brannock Device 2

6 STANDARD ARCH LENGTH FOR INITIAL CLEAT PLACEMENT

Set the arch length according to the difference between shoe size and measured arch length. If the arch length is longer or shorter than the shoe size, the cleat will be moved by 4 mm per difference in size. *For example, if the shoe size is 43 and the arch length measurement is 44, the cleat would be moved 4 mm forward, toward the toe end, from the center position of the shoe.

  • image

    If the measured arch length and shoe size are equal, set the cleat at the standard cleat position (See table below) which is at the center of the ball of the foot.

  • image

    If the measured arch length is longer than the shoe size, move the cleat forward, toward the toe side, the required length from the center position.

  • image

    If the measured arch length is shorter than the shoe size, move the cleat back, toward the heel side, the required length from the center position.

  • Standard Cleat Position is the center of the ball of the foot

    image

  • Standard cleat position table

    Standard cleat position table

    Standard cleat position table

7 OPTIMIZED CLEAT POSITION AND ADJUSTMENT

SHIMANO Brannock Device foot measurement information can also make it possible to attach cleats in the recommended cleat position at the center of the ball of the foot. After setting the cleat at the standard position, you can then fine-tune the cleat position to improve bike control.

ROAD/XC Pedaling Stability ME Pedaling and Bike control
(Rider tune)
AM Bike control CLEAT ADJUSTMENT
RANGE
Standard Wide Standard + additional rearward Rearward Standard ROAD/XC Pedaling Stability Wide Stamdard + additional reward ME Pedaling and Bike control (Rider tune) Rearward AM Bike control Standard ROAD/XC Pedaling Stability Wide Stamdard + additional reward ME Pedaling and Bike control (Rider tune) Rearward AM Bike control